Truck
bed surface temperature should be at least 68°F for proper
installation.
Warning: Improper installation will result in liner flying
out of truck!
Follow instructions exactly!!
|
|
1.
2.
3.
4.
5.
|
Read all
instructions before installing.
The floor and siderugs are shipped unzipped.
Remove floor and siderugs from box.
Zip floor and siderugs together to form the one-piece soft bed
liner.
A very aggressive hook and loop fastening system has been
designed to hold the bedliner
in open bed trucks.
|
| 6. |
A
continuous loop fastener is sewn around the liner. The bulkhead
and tailgate have two continuous strips of loop fastener sewn
along the top and bottom. The hook fasteners have a
self-adhesive backing to stick to the bed of the truck.
|
 |
|
7.
|
Lay the
Bedrug soft bed liner in the bed of the truck to determine the
exact location and fit.
Note: Some truck beds are equipped with tie-down hooks, load
extenders and other functional equipment. These may be located
on the floor, bulkhead or sidewalls. For equipment such as
this, the installer must either:
|
| |
A.
|
Cut a small
slit in the appropriate area of the Bedrug allowing the
equipment to protrude through the Bedrug into the truck bed.
(This will not damage the Bedrug.) or
|
| |
B. |
Remove
the equipment until the installation is complete, then reinstall
the equipment on top of the Bedrug.IMPORTANT: Never cut or put
slits through any seams or sewn areas of the Bedrug. This will
cause the seam to come completely apart.Refer to illustration
for completing steps 8 -14. Roll one side of the Bedrug up
exposing the floor area where the 3" strip of hook fastener
is to be adhered. |
| 8. |
Roll
one side of the Bedrug up, exposing the floor area, where the
3" strip of hook fastener is to be adherred. |
| 9. |
Using
a clean lint-free cloth, clean this area thoroughly using
NON-PETROLEUM based solvent. Then with a separate cloth, clean
the same area again with alcohol. If the cloths become visually
soiled, replace them with clean ones. |
| 10. |
Attach
hook fasteners to the loop. For siderugs, be sure to place the
2" long hook fasteners at the locator marks which are
molded into the foam. Remove the protective liners for the hook
fasteners exposing the adhesive. (See Illustration) Lay the
Bedrug down, then FIRMLY rub the fastener(s) down VERY
AGGRESSIVELY to assure full engagement of the fastener(s) and
the adhesive.
Note: Truck bed surface temperature should be 68°F or higher
in order for the hook fastener to achieve maximum adhesion.
Also, never contaminate the adhesive by touching it with your
fingers. |
| 11. |
Repeat
steps 9 and 10 for the opposite side of the Bedrug. |
| 12. |
Repeat
steps 9 and 10 on the bulkhead. |
| 13. |
Repeat
steps 9 and 10 on the siderugs. |
|
14.
|
Repeat
Steps 9 and 10 on the tailgate.
|
